Ok so I'm going in the morning to disassemble the press!
Any words of wisdom from those who have done this before, before I get up there?
I'm going to make sure that "EVERYTHING" is labeled and marked before disconnecting it.
Are there any special tools I need to take?
I'm just afraid I'm gonna get there and not have everything I need!! Lol.
Are the printheads cool to just set on the ground, or should I build some kind of support for them on the pallets?
I've watched the m&r vids on setting up a sportsman over and over and over.
Is the gauntlet pretty similar as far as overall procedure of setting up? I'm planning on just going backwards of the vid for the tear down?
Any words of advice word be great!!
Also looks like we are using a pallet jack and a lift gate to load everything. Fork truck plan fell through on the load end... I have a fork truck available for the unload at my shop.
Any words of wisdom from those who have done this before, before I get up there?
I'm going to make sure that "EVERYTHING" is labeled and marked before disconnecting it.
Are there any special tools I need to take?
I'm just afraid I'm gonna get there and not have everything I need!! Lol.
Are the printheads cool to just set on the ground, or should I build some kind of support for them on the pallets?
I've watched the m&r vids on setting up a sportsman over and over and over.
Is the gauntlet pretty similar as far as overall procedure of setting up? I'm planning on just going backwards of the vid for the tear down?
Any words of advice word be great!!
Also looks like we are using a pallet jack and a lift gate to load everything. Fork truck plan fell through on the load end... I have a fork truck available for the unload at my shop.